END CAP

Figure 42-Disconnecting Wire to License Plate Lamp

Figure 43-End Cap Components

REMOVAL

1. Disconnect wires for license plate light at lower left-hand inside corner as shown in Figure 42. NOTE: It may be necessary to remove interior trim at rear of Motor Home to gain access to license plate wiring connector.

2. Remove screws from interior trim to end cap.

3. Remove end cap to body retaining screws (32) from end cap (See figure 43).

4. Remove end cap from body.

INSTALLATION

1. Check seal to make sure it is still intact. Replace seal, if necessary.

2. Position end cap in place and install 32 retaining screws.

NOTE: The seven lower screws are self-tapping screws while the 25 screws on the sides and top of the end cap are hi-low screws.

3. Install screws retaining interior trim to end cap.

4. Reconnect license plate wiring.