Figure 29-Entrance Door Adjustment-Vertical
ENTRANCE DOOR ADJUSTMENT
The door maybe adjusted vertically by loosening the bolts at both hinges as shown in Figure. 29. Horizontal adjustment may be made by shimming or removing metal at the shaded area of the hinges as shown in Figure 30.
The entrance door seal is replaceable. Clean old seal from doorframe, apply adhesive to frame then install new seal.
1 . Remove four (4) hinge to door frame attaching bolts.
2. Remove door.
Figure 30-Entrance Door Adjustment-Horizontal
1. Install door.
2. Install four (4) bolts, torque to 25-30 ft. lbs.
3. Check for leaks and correct as necessary.
Figure 31-Door Lock
ENTRANCE DOOR LOCK REMOVAL
1 . Remove lower door trim panel.
2. Remove lock button.
3 . Remove lower window moulding.
4. Remove upper trim panel and inner handle assembly by
loosening screws shown in Figure 32 and removing all other screws. Use care
when removing panel to avoid damaging door handle mechanism.
5. Remove cotter pin from handle control rod. Slide rod out
of lever at lock mechanism.
6. Remove actuator lever pin and lock button rod clip. See
Figure 33.
7. Remove (2) screws from latch assembly at doorframe. Remove this portion from the door.
8. Remove four (4) nuts and lock tumbler clip. Remove lock
mechanism. See Figure 33.
1. Check sealer around lock opening in door, replace or fill in as required to insure proper seal between lock assembly and door.
2. Apply a liberal amount of “lubriplate” to all contacting
surfaces. Secure assembly with four (4) nuts.
3. Install lock tumbler and secure with clip.
4. Install latch assembly on door frame and loosely secure with two (2) screws on door frame.
5. Install lock button rod clip and actuator lever pin as
shown in Figure 33.
6. Install inner panel and handle assembly . At the same
time guide handle rod into lever at lock mechanism.
7. Install cotter pin to secure rod to lever.
8. Secure upper trim panel with screws .
9. Install lower door trim panel and window moulding.
Figure 32-Removing Trim Panels
Figure 33-Lock Assembly
1. Remove entrance door. Refer to "Door-Removal"
earlier in this section.
2. Remove two (2) bolts per hinge.
3. Remove hinge.
INSTALLATION DOOR HINGES
1. Install hinge on door frame and two (2) bolts. Torque to
25-30 ft. lbs.
2. Install entrance door. Refer to "Door-Installation" earlier in this section.